tnbta.blogg.se

My ScreenLogic device stopped responding to inputs or is acting strangely.

Verify the wiring to the protocol adapter and IntelliTouch Load Center. You can unplug and plug back in the wireless router to reset it.ģ. You can use a paper clip to reset the Protocol Adapter by pressing the recessed reset button. Cycle the power to both of these devices. These two devices should be located near one another. Locate your ScreenLogic Protocol Adapter and wireless router. If step 1 does not fix this issue, go to step 2.Ģ. The Tablet reboot process will take approximately 20 seconds.Ĭ. Wireless Tablet – Press the Suspend button located on the left-side of the Tablet for approximately 4 See page 8 for more information about this button.ī. Press the wireless enable/disable button to enable the wireless radio. If a wireless connection does still not exist, make sure that the wireless radio has not been disabled. Reboot process takes approximately 30 seconds. PDA – Use the PDA stylus to push the reset button located on the back side of the PDA. In most cases, the easiest way to re-establish a connection is to perform a cold boot of the ScreenLogic device:Ī. Make sure your wireless ScreenLogic device (PDA and/or Tablet) are connected to the ScreenLogic If ScreenLogic has been previously working without a problem, try the following steps to resolve the problem:ġ. If the Configuration program displays “Looking for controller,” for longer then 60 seconds when you start IntelliTouch ScreenLogic, this may indicate a communication problem somewhere in the system.

Why does the Configuration program say “Looking for Controller”? Note: If you purchased a PDA, In-wall touch screen, or Tablet, a CD-ROM is also included that contains the ScreenLogic PC interface for your Windows XP computer. For Technical Support contact information, see page viii. Please consult your manufacturer documentation for other questions. Technical support for non-supported devices is not available. IntelliTouch ScreenLogic can only be used with the provided ScreenLogic PDA, Tablet, and in-wall Touch Screen devices. Use the following information to resolve general ScreenLogic operation issues.īefore contacting Pentair Water Technical Support, please note that Technical Support personnel can only assist with relevant questions regarding IntelliTouch ScreenLogic hardware and software.